During the dedicated time for all HECC systems (scheduled for October 26-29), the Shift transfer tool will be upgraded with several enhancements, which are listed below. The upgraded Shift tool will be available when the systems come back online after the dedicated time.

Please note that any transfer active at the time of the upgrade will be stopped and cannot be restarted. Also, status information for transfers completed before the upgrade will no longer be available.
    
Important: If you use Shift for remote transfers through the Secure Unattended Proxy (SUP), you should answer "y" when prompted to upgrade during key generation. Remote transfers without the upgrade may operate erratically and will not have the enhancements listed below.

The following options will be added to Shift:

--monitor

Shows real-time status of currently running transfers.

--pipeline

Allows parallel processing of verified files to begin while the transfer is still ongoing.

--last-sum

Queries the last computed checksum of any file or tar entry previously transferred with Shift (for transfers after the upgrade).

--force

Allows overwrites of existing read-only files.

--restart=ignore

Allows transfers with unrecoverable errors to run to completion by ignoring all files and/or directories to which the errors pertain.

In addition, Shift will have the following new features:

• Silent corruption detection of files previously transferred with Shift (for transfers after the upgrade) during transfers thereafter.
• Advanced --older/--newer syntax to more precisely specify atime/ctime/mtime combinations of interest.
• Ability to exclude a subset of attributes from {acl,mode,owner,stripe,time,xattr} during --no-preserve.
• Advanced striping syntax to allow different files in the transfer to be striped dynamically according to different formulas.
• Optimization of file attribute collection to increase speed of initial source directory traversal.
• SSL encryption of data streams in fish-tcp transport when --secure specified (requires perl IO::Socket::SSL module installed on the client system).
• Ability to exclude status emails in a subset of states from {alert,done,error,run,stop,throttle,warn}.

For more information about using Shift, see the following section in the Knowledge Base:  Using Shift for Local and Remote Transfers 

If you have any questions or need assistance, please contact the Control Room at (800) 331-8737, (650) 604-4444, or support@nas.nasa.gov.